Flow Through Heater mkII

FTH (Flow Through Heater) MkII

from Ferro Techniek

 

FTH mk1.5 construction

FTH mkII is an ultra fast high pressure (15bar) water flow through heater based on a thick film heating element. Water runs at high speed along a channel over the heater. This results in hot water in just seconds. FTH mkII delivers water up to boiling temperature and can even create steam! The heater will fastly improve the sustainablity of your application. This is confirmed by this LCA, conducted by TNO.

Features:

  • Heat up temperature to 100°C, in just seconds!
  • Instant hot water! No water storage!
  • No standby mode required / low energy consumption
  • Integrated temperature sensing (NTC) and thermal protection (E-Fast)
  • Prepared for electronic volume measurement
  • Suitable for steam generation
  • Friendly with regards to lime scale forming and easy to descale
  • Compact design
  • Food safe materials / full stainless steel water channel

Specifications *

  • Power range: 1000W – 2300W / 230VAC and 1000W – 1800W / 120VAC (UL)
  • Element power: single or dual sections (power ratio approx. 2:1)
  • Dimensions (W x L x H) : 90mm x 120mm x 40mm
  • Flow rate: max. 12 ml/s (pressure drop <1 bar)
  • Max. operating pressure: 20 bar, burst pressure : 40 bar
  • Outlet NTC sensor: Fast response, 50kΩ @25°C, ß25/80=3976K
  • Water connections for low pressure hoses: barbed fitting for ø5mm tube
  • Water connections for high pressure application: fitting to 4x2mm Teflon tube
  • Electrical connections heater: L, N, PE, E-Fast – 4,8mm x 0,8mm terminals
  • Electrical connections NTC: JST XH-series 2-pole
  • Overheat protection: E-Fast, NTC, thermal fuse
  • Time constant heating: <5 seconds
  • Options:
    • Thermal fuse set
    • Electronic control module (outlet temperature, overheating protection, dispensed volume)

* Deviations from these specifications upon request

FTH heating system FTH control PCB